Bullet Casting

Vince · Posted: Sat Feb 06, 2010 12:10 am Post subject: Re: Bullet Casting

Hey Stoves...good idea mate. Another thing you can do is get one of them little bags that clip onto your ejection port...cut the bottom out of it and the drop at your feet.

Cheers, Vince

wiersy111 · Posted: Sat Feb 06, 2010 12:15 am Post subject: Re: Bullet Casting

Might have to try that one. I thought about pinning up some screening on the posts to keep the brass from going awol on me.

Vince · Posted: Sat Feb 06, 2010 12:32 am Post subject: Re: Bullet Casting

Yep...you can do the same with a tarp...pin it up so the brass rolls back down to beside you...bit of messing around setting it up though.

Still reckon the bag is the way to go...I think you can also get one that attaches to your hand/wrist.

Brass Catcher

Cheers, Vince

stovepipe · Posted: Thu Feb 11, 2010 1:46 pm Post subject: Re: Bullet Casting

From a bench:
PVC frame (2 tees, 2 elbows, X" x Y"- you decide), conduit brackets fastened to edge of bench, use screen or suitable material to cover frame, leave legs proud on one end of frame to slip into brackets and viola!
Get creative with this and the brass can roll into a can, box etc...

Off-hand:
the 8'x10' blue tarp works great in the snow. Stuff a can in the valley on one end and broom the brass into it.

So easy a Chambered could do it!! Laughing

hunterjoe21 · Posted: Thu Feb 11, 2010 9:34 pm Post subject: Re: Bullet Casting

stovepipe wrote:

Off-hand:
the 8'x10' blue tarp works great in the snow. Stuff a can in the valley on one end and broom the brass into it.

So easy a Chambered could do it!! Laughing

Are ya taken bets on that???

wiersy111 · Posted: Thu Feb 11, 2010 10:34 pm Post subject: Re: Bullet Casting

I'd bet 5-1 he can't.

Vince · Posted: Thu Feb 11, 2010 11:10 pm Post subject: Re: Bullet Casting

Stop pickin' on poor old Chambered, ya miserable buggers. Laughing

Cheers, Vince

stovepipe · Posted: Fri Feb 12, 2010 9:50 am Post subject: Re: Bullet Casting

Hi Chambered! Wave