Search found 23 matches

Thanks guys I will check that out. It is kinda worrysome having this happen when deer season is coming up......

For the second time the bolt in my rifle didnt want to lock in. One time after running a boresnake through the barrel and last night when I cleaned the rifle. On both occassions when I tried to put ...

I recently posted on another forum that I suspect that my rcbs 505 scale sticks or drags and is causing strange readings on the chronograph. Dont know why the scale does this. I am constantly tappin ...

Yes I have a boreguide. So far I think I will let the lube work and see about pushing it through later.......unless a miracle cure comes along...!!!!

I was cleaning the .243 with a borebrush covered with a cloth patch. Trying to swab the barrel with copper remover. Well the bore brush WAS A LITTLE SNUG going in. Then when it was in about 5-6 inc ...

Thanks guys....you are all making me smarter every day........

Thank you all who responded to my question regarding David Tubbs and his lapping rounds he sells. I think after reading all the fine advice I would like to do the lapping on my own. Can someone help ...

I was at his website and he claims that using his bullets that we reload....when all 50 rounds are shot per his load instructions....the barrel of the gun will be "lapped". The bullets are shot in t ...

While setting up my chronie I had a guy say that 7 feet was fine because that was how he set his up when they first came out. Manual said 10 feet. I went along with the guy. Just hoping i didnt sho ...

Hey thanks again guys for the input...........buncha good people on this forum.

My buddie told me if I leave the brass in the pillow case in the washer long enough I would have 7mm mags.... Very Happy

Thanks for the humor and additional comments on cleaning. I think the next time I d ...

Thanks shootist.........i couldnt believe it when I put the bushing in the die and ran the brass...(almost typed bras !!)...I was dumbfounded holding the calipers and the brass and not knowing where ...

I just bought a neck sizing die. And it occured to me that I am not sure where to measure the neck before and after I run the brass through the die. Should the entire neck be the same size when I r ...

I know others have done this but I got to share my experience. I put some of my .308 brass in a pillow case along with an air filter from the furnace. Clean unused one. One of those sorta thin spon ...

Hey !!!!!!!!! Thanks all for the great information. I am shooting a remington bdl vs .308 with a mil dot scope. I have noticed that the IMR 4895 powder at 43.5 grains just barely gets to the neck of ...