Moved to Reloading Forum:

kreifelsm wrote:

I am looking for a load for my 300 Wby using the 200 Accubond and either RL-25 or IMR 7828 powder.

Before I can offer help, I need to know if you are loading Remington or Weatherby cases.
Keep it coming...

I have a majority of Remington cases. I also have 50 hornady and approx the same in the weatherby cases. I shpuld have mentioned this initially...my bad

Keep in mind you should start at 10% less. Remington case, Federal 215 primer, 80 grns of IMR 7828 powder, COL 3.5 inches, for a 200 grn bullet, 2912 FPS @ 60,900 psi.

For a 200 grn Nosler Partition, same primer, same COL, same case, 83.2 grns of RL-25 for 2940 FPS @ 59,700 psi. (My load).

Remember to start at 10 % less, look for pressure signs as you work up. Neither of these loads are for the 200 grn Accubond, but, I don't know why you couldn't use it for either of the above loads.

Have fun.
Keep it coming...

Thanks a bunch...I'll start loading some today, and let ya know how it turns out after I get to the range

Good shooting
Keep it coming...

Ok, it has taken me awhile to get out to the range but finally I was able to get away from work and home. I used Hornady brass for this load and it worked out fantastic. With my Mark V deluxe the groups were right at a 1/2 in at 100 yds.

200 Nosler Accubond
Fed 215M primer
81.5 Grns RL-25
COL-3.6