Chamber Inserts/Adapters

PaulS · Posted: Tue Jun 25, 2013 5:53 pm Post subject: Re: Chamber Inserts/Adapters

It shouldn't be hard to make a square slot in the adapter and then fit it with an extractor that lines up with your ejector. Us a cut in the "outside" of your extractor and pin it to the adapter.

I could probably draw one up that you could mate to your gun with a bit of mods.

MacD · Posted: Tue Jun 25, 2013 10:19 pm Post subject: Re: Chamber Inserts/Adapters

I was thinking that if you cut about 500 mm or so to the centre at the back and then sliced that piece out you could use a stiff coil spring set into the adapter and the cut out piece. Bevel the piece at the back so closing the gun compresses the piece and spring into place with the shell rim tight in place.in both. When the gun is broken open quickly the piece will snap back out and eject (hopefully) the shell. Of course I am assuming a break open gun.